Custom slotted angle bar is mainly designed for mounting on wooden, concrete or metal telecom poles, and it's called cross-arm bracket. This pole line hardware is made of angle bar with pre-drilled holes for the parallel deployment of overhead lines, and it is installed with a pole bracket adapted for its mounting support. It provides fastening points for dead-ending or suspension applications, and we have cross-arm 15 holes, 13 holes, 11 holes and 5 holes available.

Description

Our cross-arm bracket is made of high strength angle bar, and it is hot dip galvanized according to EN ISO 1461 which provides extended service life to this support arm pole line hardware under very corrosive environment. This cross-arm bracket, designed for overhead telecommunication lines and routing cables, can offset cables form poles, and it's widely used for pole, extension bracket and post mounting on fiber and copper networks. All the edges have been grinded for safe installation.
 

Specification

Steel grade: Q235B

Tensile strength: 470-630MPa

Angle bar: 40mm x 40mm x 4mm

Length: 450mm, 850mm, 1050mm or customized

Hole size: 15mm, 17mm and 19mm or customized

Hole space: 40mm, 50mm and 60mm or customized

Galvanization thickness ≥70μm according to ISO EN 1461

Production solution: punching or laser cut holes before hot dip galvanization

Fabrication tolerance according to ISO 2768-M

Fabmann supplies a wide range of slotted angle bars with hot dip galvanization for storage racking system, power transmission and telecom industries, and this special cross-arm brackets can lift cables from poles and protect them against environmental constraints. Our production team takes very strict on hot dip galvanization, and the galvanization thickness is no less than 70μm according to ISO 1461. Plus, all the pre-punched holes have very tight tolerance for precise installation at construciton site.