Suspension Clamp

1.Follow the procedure in step 6 to install an outer pre-twisted wire in the lower half of the rubber jig.

2.Install all outer preformed armor rods . Make sure that the gap is uniform and does not cross.

3.Hand the outer edge of the outer strands of the outer winding wound naturally. Do not use any tools to avoid damaging or scratching the cable.

4.To hang the center of the suspension clamps as center,the aluminum clamp inserted outside the outer wire and hanging up.

5.Fix the nuts and install the closure.

6.The U-shaped ring is fixed on the tower or cement rod fastening fixture.install the nuts.

Note：

1.The preformed suspension clamps are used in ADSS cables and OPGW cables in two major categories.

2.Single angle vertical suspended clamp applicable line shall not exceed 25 degrees, use double suspension line clamp for vertical angle 25 degrees to 60 degrees.

3.This product can only be used by professional trained professionals.

4.The fittings, cables and personal safety shall be ensured during the operation.

5.You can not arbitrarily change the number and length of its components.

6.The outer preformed suspension clamps can not be reused.

7.If you have any questions, please contact our technical department.

Product applications:

Hot Tags: suspension clamp, China, suppliers, manufacturers, factory, wholesale, in stock, Remaining Cable Rack, Preformed Armour Rods, Preformed Guy Grips, Preformed Strain Clamps, Preformed Tension Sets, Suspension Clamp